HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 129)

Configuring the Virtual Connect domain using the CLI 129
>remove radius-group MyGroup
To display RADIUS settings and groups:
>show radius
>show radius-group
IMPORTANT: The RADIUS or TACACS+ server must be set up on a host machine on the
management network and configured with users and VC attributes. For more information, see the
HP Virtual Connect for c-Class BladeSystem User Guide on the Installing tab of the HP
BladeSystem Technical Resources website
(
http://www.hp.com/go/bladesystem/documentation ).
Configuring TACACS+ authentication support for users
To set TACACS+ properties:
>set tacacs serveraddress=192.168.0.110 enabled=true serverkey=xyz1234
To display TACACS+ settings:
>show tacacs
IMPORTANT: The RADIUS or TACACS+ server must be set up on a host machine on the
management network and configured with users and VC attributes. For more information, see the
HP Virtual Connect for c-Class BladeSystem User Guide on the Installing tab of the HP
BladeSystem Technical Resources website
( http://www.hp.com/go/bladesystem/documentation ).
Configuring role-based authentication settings
To set the authentication order:
>set role domain Order=ldap,radius,tacacs
To display the authentication order:
>show role domain
Network setup
To establish external Ethernet network connectivity for the HP BladeSystem c-Class enclosure:
1. Identify the MAC addresses to be used on the server blades deployed within this Virtual Connect
domain.
2. Set up connections from the HP BladeSystem c-Class enclosure to the external Ethernet networks.
These connections can be uplinks dedicated to a specific Ethernet network or shared uplinks that carry
multiple Ethernet networks with the use of VLAN tags.
Configuring MAC address ranges
To configure MAC address ranges, use the set domain command.
To use VC-defined MAC addresses:
>set domain MacType=VC-Defined MacPool=10
To use factory-default MAC addresses:
>set domain MacType=Factory-Default