HP NonStop G-Series - Manual (Page 127)

NonStop AutoTMF Software Commands
HP NonStop AutoTMF Software User’s Guide—429952-014
6-53
CREATE MAPDB
option
CATALOG SQL-catalog
SQL catalog where MapDB tables are to be registered. The catalog may also
be specified either by the
VOLUME command or by specifying a catalog
attribute for the =_DEFAULTS define.
If omitted, the tables are registered in the catalog where SysDB tables are
registered.
SECURE "rwep"
specifies the READ, WRITE, EXECUTE and PURGE security attributes of
MapDB tables.
MONITOR process-name
NonStop AutoTMF software monitor process to be associated with MapDB.
The name must have 5 characters, including the $. The default is $ZESC.
PRIMARY cpu-number
cpu (in the range of 0 to 15) of the primary monitor processes. Used when the
monitor process is started.
BACKUP cpu-number
cpu (in the range of 0 to 15) of the backup monitor processes. Used when the
monitor process is started.
PRIORITY process-priority
priority (in the range of 1 to 199) for the monitor process. Used when the
monitor process is started.
HOMETERM file-name
home terminal for the monitor process.
If omitted, the home terminal is set to the default EMS collector. The default
EMS collector is $0, or the EMS collector configured by setting the global
parameter EMSCOLLECTOR.
Note that internally, the default hometerm of the monitor is $ZHOME, as
displayed by the TACL command STATUS $<process-name>, because an
EMS collector cannot be specified as the hometerm of a process when the
process is launched. Functionally however, the home terminal for the monitor
process is the default EMS collector, as shown by the AutoTMF
STATUS
MONITOR command.
When a MapDB is created, the monitor process is started to provide access to MapDB
tables. Operational procedures should be updated to start the monitor after a system
cold load.