HP EliteBook 8560w Mobile Workstation User Manual
Page 18

4.
In the Device Configurations window, select RAID under SATA Device Mode. Click Confirm.
The following message is displayed: “Changing this setting may require reinstallation of your
operating system. Are you sure you want to proceed?”
NOTE:
The HDD image supplied with your computer contains drivers that allow you to switch
between AHCI and RAID modes without reinstalling the operating system. If you use a different
HDD image, you may need to reinstall the operating system.
NOTE:
Below SATA Device Mode, there is a check box for Ctrl I Prompt. If this is selected, the
Intel option ROM screen is visible during the computer bootup time.
5.
Select File > Save Changes and Exit. Then, click Yes to save the changes. If you do not want
to apply your changes, select Ignore Changes and Exit.
CAUTION:
Do NOT turn the computer power off while the ROM is saving the
f10
Computer
Setup changes, because the Complementary Metal Oxide Semiconductor (CMOS) could
become corrupted. Turn the computer off only after exiting the
f10
Setup screen.
6.
After the operating system boots, you can begin the RAID migration procedure.
14
Chapter 5 RAID volume setup
- EliteBook 8460w Mobile Workstation EliteBook 8570w Mobile Workstation EliteBook 8560p Notebook PC EliteBook 8760w Mobile Workstation EliteBook 8770w Mobile Workstation EliteBook 8460p Notebook PC EliteBook 2560p Notebook PC EliteBook 2760p Tablet-PC ProBook 6460B Notebook-PC ProBook 6560B Notebook-PC