beautypg.com

Installing an adapter in a server, Installing a low profile bracket – HP NC382T PCI Express Dual Port Multifunction Gigabit Server Adapter User Manual

Page 9

background image

Installing an adapter 9

Installing an adapter in a server

See the HP ProLiant server documentation for additional information on how to safely install a PCI card in
the server.

CAUTION:

If the server is not PCI Hot Plug compliant, power it down and unplug the power

cord from the power outlet before removing the server access panel. Failure to do so may
damage the adapter or server.

1.

Power down the server.

2.

Remove the power cord and server access panel. Then remove the cover bracket from a PCI Express
slot.

WARNING:

To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

3.

Firmly seat the adapter in a PCI Express slot and secure the adapter bracket.

4.

Replace the access panel and plug in the power cord.

Installing a low profile bracket

You may have to install a low profile bracket to complete the product installation. The low profile bracket
replaces the existing standard profile bracket shipped on the product.
To install a low profile bracket:

1.

Using a correctly sized slotted screwdriver, carefully remove the two board lock screws located at
the top and bottom of the connector.

2.

Remove the standard profile bracket and place the low profile bracket over the connector. Be careful
not to damage the connector or bind the low profile bracket to the connector.

This manual is related to the following products: