HP Netserver L Server series - Manual (Page 42)

Chapter 4 Installing Additional Memory
36
0
1
2
3
DIMM
Slots
System Board
Figure 4-4. Inserting DIMMs
Removing DIMMs
You may need to remove a DIMM module to downsize your memory
configuration or to replace a defective DIMM.
1. Log off all users, back up files, and power down the HP Netserver.
For detailed instructions, see "Powering-Down the HP Netserver," in
Chapter 1, "Controls, Ports and Indicators."
2. Pull out the anti-tip foot at the bottom of the rack. Then slowly slide the HP
Netserver chassis out from the rack as far as it can be extended.
It is not necessary to remove the HP Net Server from the rack to install
DIMMs.
3. Disconnect the power cables and all external cables.
If necessary, label each one to support re-assembly.
WARNING The power supply will continue to provide standby current to
the HP Netserver until the power cable is disconnected.
4. Remove the top cover.
Refer to "Removing the Top Cover" in Chapter 2, "Opening and Closing the
HP Netserver."