Install nas data path manager, Prerequisites, Install the software – HP StorageWorks NAS Data Path Manager Software User Manual
Page 15: Enable and disable the software
NAS Data Path Manager
15
hp StorageWorks NAS Data Path Manager Installation and User’s Guide
Install NAS Data Path Manager
Prerequisites
See
Install the Software
Use the NAS Data Path Manager software CD and the command line interface to
install NAS Data Path Manager.
1. On the NAS 8000 server, insert the CD into the server’s CD-ROM drive.
2. On a computer on the network, access the command line interface:
a.
On an MS Windows system, Select Start > Run. (This step is not
necessary for UNIX/Linux systems.)
b.
Execute:
telnet
c.
Log in as
admin and use a password, if prompted.
3. Execute the following commands.
installSystemPackage
cdrom://hpNasOs-DataPathManager-1.0-0.i386.rpm
installSystemPackage
cdrom://hpNasOs-DataPathManager-authorize-1.0-
0.i386.rpm
4. Remove the CD from the CD-ROM drive.
The software is installed, but not yet enabled.
Enable and Disable the Software
Enable and disable NAS Data Path Manager from Command View NAS.
1. If you had a browser open, close and re-open it, so that it finds the DPM
software.
2. Select the Applications tab.
3. Select NAS Data Path Manager.