ATI Technologies X1900 SERIES - Manual (Page 15)

Quick Installation 7
CHAPTER 2:
Installing Hardware
This chapter will guide you through the physical installation of your new All-
in-Wonder® X1900 Series graphics card.
Quick Installation
For experienced users and system administrators, follow these brief
instructions for installing your All-in-Wonder® X1900 card in the shortest
possible time.
Quick Installation Steps
1 Uninstall the drivers and software for your old graphics card.
2 Shut down and disconnect your computer system.
3 Remove any previously installed card.
4 Install your new All-in-Wonder® X1900 card.
5 Reassemble and connect your computer system.
6 Install the All-in-Wonder® X1900 drivers and configuration software
from the ATI Installation CD-ROM by doing one of the following:
• Run through the automatic ATISETUP utility; or
• Start > Run > X:\ATISETUP.EXE (where X is the drive letter of
your CD-ROM drive).
L If you are using a motherboard containing an on-board graphics
solution and do not intend to use it as part of a multiple monitor display,
disable it.