ADC MM701F User Manual

Page 53

Chapter 4: Managing the Modem Using the Console Port & Telnet

MM701F User Manual

Valid values for the parameters shown on the Sessions Options screen are defined in the
following table. Unless there is a special circumstance, the default values for the remaining
parameters should not be changed.

Session Parameter

Valid parameter Values

Session Name

The name assigned to the session by your service
provider—up to 15 characters.

WAN Protocol

RFC1483-Router, RFC1483-Bridge, PPPoA.

State

Enable or Disable a session.

IP Addressing

Static or Dynamic. Not applicable to bridging.

IP Address

WAN IP address supplied by your service provider.

IP Net Mask

WAN IP subnet mask supplied by your service provider.

NAT

Enable or Disable.

RIP Send

Disable, RIP1, RIP2, Rip1&Rip2.

RIP Accept

Disable, RIP1, RIP2, Rip1&Rip2.

VPI

VPI supplied by your service provider.

VCI

VCI supplied by your service provider.

QoS

Supplied by your service provider.

QoS Peak Cell Rate

Supplied by your service provider.

Encapsulation

Select VC-MUX or LLC.

PPP authentication name supplied by your service
provider.

PPP authentication password supplied by your service
provider.

Authentication

Select PAP or CHAP.

Apply

Apply Settings.