ADC MM701F User Manual
Page 52
Setting Up the WAN
46
MM701F User Manual
2
Select a session by typing the session number at the
Select session for editing prompt
to
display the
WAN Session Options
screen.
3
Type
1
to select the Session Name then type a session name.
4
Type
10
to select the VPI parameters then enter the values supplied by your service
provider.
5
Type
11
to select the VCI parameters then enter the values supplied by your service
provider.
6
If you are operating in Router mode, you also need to enter the WAN IP address and the
associated WAN IP subnet mask. Both of these values are provided by your service
provider.
7
Type
18
to immediately activate the changes that you have made for this session.
8
Select
Save New System configuration
from the Main Menu as described in
Current Configuration” on page 60
or the changes will be lost upon reboot or power cycle.
1. Session Name
Bridge
10. VPI
0
2. WAN Protocol
RFC1483 Bridge
11. VCI
35
3. State
Enabled
12. QOS
UBR
4. IP Addressing
N/A
13. QOS Peak Cell Rate
5. IP Address
N/A
14. Encapsulation
LLC
6. IP Net Mask
N/A
15. Login Name
N/A
7. NAT
N/A
16. Login Password
N/A
8. RIP Send
N/A
17. Authentication
N/A
9. RIP Accept
N/A
18. Apply
Select parameter to edit (Return to exit) ->