Setting up dhcp – ADC MM701F User Manual
Page 56

Setting Up the WAN
50
MM701F User Manual
Setting Up DHCP
This procedure is optional. Follow this procedure to enable or disable DHCP on the modem.
From the
Main Menu
, select
LAN Setup
screen and enter values for the following DHCP
parameters:
1
To enable DHCP, select
DHCP
and type
2
or
3
to choose either
Client
or
Server
(respectively)
on the
LAN Setup
menu. If
DHCP Client
is selected, you do not need to configure an IP
address.
None
disables DHCP.
2
Type
6
to enter the low range of the DHCP IP addresses as supplied by your LAN
administrator.
3
Type
7
to enter the high range of the DHCP IP addresses as supplied by your LAN
administrator.
4
Type
8
to enter the default gateway address that is provided to the requesting DHCP
client—only if you are operating in server mode. This IP Address is also available from
your LAN administrator.
DHCP Range Low Address
Enter the IP address supplied by your LAN administrator.
This is the lowest IP address value that the MM701F can
serve when configured as a DHCP server.
DHCP Range High Address
Enter the IP address supplied by your LAN administrator.
This is the highest IP address value that the MM701F can
serve when configured as a DHCP server.
DHCP Gateway Address
Enter the IP address of the default gateway that is provided
by the LAN administrator for devices on the LAN. The
MM701F must be configured as a DHCP server and
provides this gateway IP address to requesting DHCP
clients (such as PCs) on the LAN.
DHCP DNS
Enter the IP address of the Domain Name System (DNS)
server that is provided by either the service provider or the
LAN administrator. The MM701F must be configured as a
DHCP server and provides this DNS IP address to
requesting DHCP clients (such as PCs) on the LAN.
The DNS server maps human-readable addresses to IP
addresses. A human-readable address is one such as:
maggie.copro.company.com.
The DNS resolver on the server translates this to a numeric
value.
Apply
Apply Settings.
LAN Parameter
Valid parameter Values