Airlink101 Airlik 101 N300 - Manual (Page 28)

27
You can click “Continue” to back to previous setup page to continue on other setup procedures,
or click “Apply” to reboot the router so the settings will take effect (Please wait for 30 seconds
while router is rebooting).
2.4.4 AP Bridge - Point to Multi-Point Mode
In this mode, this wireless access point will connect to up to four wireless access points which
uses the same mode, and all wired Ethernet clients of every wireless access points will be
connected together. You can use this mode to connect a network to other networks which is
physically isolated.
Please note that when you set your access point to this mode, it will not accept regular wireless
clients anymore.
Diagram 4: Point to Multi‐Point Bridge mode application
When you select ‘AP Bridge-Point to Multi-Point’, the following options will be displayed: