LG 26LD340H - Manual (Page 260)

48 206-4186
This section describes how you can reset a TV that is currently in FTG Mode to Pass-through Mode. Note
that the reset to Pass-through Mode will also restore all factory default settings on the TV.
FTG Mode via CPU
There are three options for resetting Pass-through Mode on TVs that are in FTG Mode via the CPU. The
first and second options enable you to reset a single TV to Pass-through Mode, while the third option
enables you to reset multiple TVs to Pass-through Mode at one time.
• A predefined value for Installer Menu item 117 FACT DEFAULT enables access to initiate a factory “IN-
STOP” process that will reset the TV to Pass-through Mode. Contact technical support for the required
value for Installer Menu item 117 and for additional information on performing the IN-STOP from the
Installer Menu.
• Using a USB memory device, “Teach” an FMA Configuration file that only contains a “0 Mapped
Channels” FTG Channel Map to the TV. Refer to “Creating an FMA Configuration File using the FTG
Configuration Application” and “Teaching FMA Configuration to a TV” on pages 31 and 32, respectively,
for further information.
• If your system uses a Pro:Centric server for configuration, use the Pro:Centric Admin Client to load an
FMA Configuration file that only contains a “0 Mapped Channels” FTG Channel Map on the Pro:Centric
server. Refer to the Pro:Centric™ Server Admin Client User Guide for further information.
FTG Mode via EBL
There are three options for resetting Pass-through Mode on TVs that are in FTG Mode via the EBL. The
first and second options enable you to reset a single TV to Pass-through Mode, while the third option
enables you to reset multiple TVs to Pass-through Mode at one time.
• A predefined value for Installer Menu item 117 FACT DEFAULT enables access to initiate a factory “IN-
STOP” process that will reset the TV to Pass-through Mode. Contact technical support for the required
value for Installer Menu item 117 and for additional information on performing the IN-STOP from the
Installer Menu.
• Using a direct PC-to-TV connection, “Write” an unpopulated Channel Map—that is, a Channel Map with
zero channels—to the TV. Refer to the “FTG Mode via EBL” procedure on page 35 and/or the Free-To-
Guest (FTG) Configuration Application manual for further information.
• If your system uses an FMA for broadcast configuration, configure the FMA device with an FMA Config-
uration file that only contains a “0 Mapped Channels” FTG Channel Map to broadcast to the TV EBL(s).
Refer to the Free-To-Guest (FTG) Configuration Application manual and/or the Installation & Setup
manual for the FMA device for further information.
Resetting a TV to Pass-through Mode