Cloning procedures (cont.) – LG 26LD340H User Manual

Page 190

206-4177

(Optional) Set the Clock
Set the time on a Master TV’s clock. (If the time has already been copied

from a TV into the TLL-1100A clone programmer, you can set the Master TV’s

clock by copying the time from the clone programmer.) The TLL-1100A can

copy the current time to both a Master TV and to the clone’s internal clock—

accurate to within one minute.
Since the TLL-1100A’s time cannot be set directly, the current time needs to

be copied from an LG TV equipped with an enabled MPI port.
After the time is copied to the TLL-1100A clone programmer, the current time

will be maintained and can then be transferred to another TV. (This can be a

Master TV or another TV which has already had the features set up.)

Teach Master TV Setup to Target TV
1. When Learning is complete, disconnect the MPI cable from the Master TV.
2. Ensure the Target TV is in Pass-through Mode, and then use the Installer

Remote to enter the Target TV Installer Menu: Press MENU repeatedly until

the on-screen setup menus lock up, and then press 9-8-7-6 +

ENTER

3. Set Installer Menu item 117 FACT DEFAULT to 001, and press ENTER.

When the value changes back to 0, press ENTER again to exit the

Installer Menu.

4. Tune/set the TV to an analog channel or Aux source, and then connect the

MPI cable to the MPI port on the Target TV. The Clone Selection Menu will

display on the TV screen.

5. Ensure the correct Memory CBank(X) is selected on the TLL-1100A.
6. Press 2 on the Installer Remote to select TEACH TO TV from the Clone

Selection Menu. Then, press ENTER to transfer the Master TV Setup to

the Target TV.

Teaching usually takes 3 to 4 minutes. “TEACHING IN PROGRESS” will

be displayed on the screen during Teaching. When the Teaching process is

complete, a “TEACHING COMPLETE” message will be displayed.

7. When Teaching is done, disconnect the MPI cable from the Target TV, turn

OFF the TV, and unplug the TV power cord for 15 seconds.

8. Reconnect the TV power cord, and turn ON the TV. The Master TV Setup

should be resident on the Target TV.

CLONE SELECTION MENU

Selected Bank: CBankX Saved

(1) LEARN FROM TV

(2) TEACH TO TV

(3) SET CLONE CLOCK FROM TV

(4) SET TV CLOCK FROM CLONE

(5) DISPLAY TV SETUP

(6) DISPLAY CLONE SETUP

CLONE CLOCK = XX:XX

TV CLOCK = XX:XX

THE CLONE IS VERSION VX.X.X

To change menu items, press

channel keys or digits.

To execute item, press Enter.

Cloning Procedures (Cont.)

Learning / Teaching a Master TV Setup using a TLL-1100A Clone Programmer (Cont.)