Aviom A-16CS - Manual (Page 43)

33
To use Held Solo Mode:
• Press and hold the S
OLO
button.
• While holding down the S
OLO
button, press and then
release any Channel button.
• You can now release the S
OLO
button. (If you release
the S
OLO
button before releasing the Channel button,
Held Solo Mode will not be engaged.)
• The Channel that you pressed is now soloed, and the
Solo LED is flashing.
• To solo another Channel, press any Channel button.
• To exit Held Solo Mode, press the
S
OLO
button again.
You can also exit Held Solo Mode by pressing the R
ECALL
, G
ROUP
, or
M
UTE
buttons.
Remember that the system can only enter Held Solo Mode from the
normal Mix Mode. If you currently have a Channel temporarily soloed
(the Solo LED is lit solid), you must exit the temporary Solo Mode (by
hitting another Channel button or the S
OLO
button) before you can
enter Held Solo Mode.
Note: The status of Solo Mode is not saved with a Preset.
Muting a Channel
While creating a mix, any Channel or combination of Channels can be
muted. Unlike the Solo Mode, the changes you make with the M
UTE
button can be saved as part of a Preset.
To mute a Channel:
• Select the Channel first
• Press the
M
UTE
button
• The yellow LED in the Channel button lights
To unmute a Channel:
• Select a muted Channel
• Press the
M
UTE
button
• The yellow LED in the Channel button will go out
Additional Channels can be muted or unmuted by following the same
procedure—first select the Channel, then press the M
UTE
button.