Water Inc WI-BG-PURE - Manual (Page 8)

2
SMARTAP
®
WATER QUALITY MONITOR
The Body Glove Reverse Osmosis System incorporates a proven performance indicator. Our patented Smartap
®
Water Quality
Monitor uses dual probe LOGIC PULSE MEMORY technology to accurately indicate membrane performance. A split-second
power pulse compares the feed water Total Dissolved Solids (TDS) level with that of the product water. Then, by reversing the
polarity of the electronic pulse, the probes are cleaned and kept free of chemical plating. A nine-volt alkaline battery provides
power to the Monitor. For optimum monitor performance, the battery should be replaced each time system is sanitized (or once a
year).
NOTE: Monitor Troubleshooting Indicators and Common Solutions are shown
in Table 5 on page 12 of the Owner's Guide..
Push Button Actuated Smartap ®
Pressing a test button located on the Body Glove RO cover activates monitor. When the button is pressed, and momentarily
held down, the monitor reports the membrane status by illuminating a light located next to test button. A green light means the
system is operating normally. A yellow light indicates the system needs servicing (membrane may be depleted or fouled).
While the button may be pressed at any time, the most accurate readings are obtained when the system is making water for
at least 10 minutes.
INTER-COMPONENT CONNECTIONS
Connections between cold water supply line, Body Glove RO Module, storage tank, product water faucet and drain line are
accomplished using plastic tubing and push-together quick-connect type fittings.
PLASTIC TUBING
1. Cut tube ends square and straight. Do not deform
tube (i.e., cause tube to compress its diameter so it
is no longer round).
2. Make sure outer surface of tube is clear of marks or
scratches for a length equal to twice tube diameter.
This allows "O" ring to seat properly against tube.
3. Avoid sharp changes in direction when routing
tubing. Sharp turns cause tubing to flex and deform,
which reduces flow capacity and may increase
lateral stress on the fittings, causing leakage.
QUICK-CONNECT FITTINGS
Fittings consist of two parts: a Body and a colored collet
and symbol. Collet color and symbol corresponds to
tubing to be used at that connection (Figure 2.A. below).
1. To install a tube, push it through Collet until it seats
firmly at bottom of fitting (Figure 2.A and 2.B.).
2. To remove a tube, push and hold Collet against
Body while pulling tube out (Figure 2.C.).
A. Push tube through Collet into Body. B. Tube must seat firmly at bottom of
fitting. C. Push Collet against Body and pull
tube to release.
Figure 2: How to Use Quick-Connect Fittings