Water Inc HP - 9100TS - Manual

9100TS
QUICK START
INSTALL 9100TS ACCORDING TO MANUAL AND LOCAL PLUMB-
ING CODES
SLOWLY TURN ON INCOMING SIDE OF BYPASS
WAIT FOR WATER TO FILL TANK AND AIR TO STOP
PUSH AND HOLD “REGENERATE” TO START CYCLE
IMMEDIATELY AFTER THE VALVE STARTS –PUSH AND HOLD
THE “SET” AND “UP” BUTTONS
THE “HOUR GLASS” ICON WILL START FLASHING
THE VALVE WILL NOW CYCLE THROUGH TO THE END WITH-
OUT STOPPING
REPEAT TWICE ON EACH TANK
ADJUST HARDNESS SETTING
OPEN OUTGOING SIDE OF BYPASS VALVE
CHECK FOR LEAKS
ADD SALT TO THE BRINE TANK
1 2 3 4
Figure 5
1. SET. Used to accept a setting that nor-
mally becomes stored in memory. Also
used together with the arrow buttons.
2. DOWN arrow. Generally used to scroll down
or decrement through a group of choices.
3. UP arrow. Generally used to scroll up or in-
crement through
a group of choices.
4. REGENERATE OR EXTRA CYCLE. Used to
command the controller to regenerate.
800.322.WATER(9283) ● waterinc.com