Noises, 6 electrical connection – Electrolux ERF4110AOW User Manual

Page 32

• Remove the plinth .
• Remove the cap (A) and position it on

the opposite side.

• Unscrew the lower hinge (C) and the

washers (B)

• Position the pin and the washers on the

opposite side .

• Re-screw the upper hinge.
• Refit the door.
• Remove the covers. (B) Remove the

cover pins. (A)

• Unscrew the handles and fix them on

the opposite side. (C)

• Re-insert the cover pins (A) on the op-

posite side

• Do a final check to make sure that:

– All screws are tightened.
– The door opens and closes correctly.

If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.

9.6 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic

power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.

10. NOISES

There are some sounds during normal
running (compressor, refrigerant circula-
tion).

32 www.electrolux.com