Bosch HBL8461UC - Manual (Page 5)

English 2
Preparation
Before You Begin
Tools and Parts Needed
• Phillips head screwdriver
• Star head screwdriver (T20)
• Measuring tape
• Drill with bit (1/8")
Parts Included
• Phillips head screws (6)
General Information
Power Requirements
The outlet must be properly grounded in accordance with
all applicable codes.
For Best Installation
The oven can be difficult for two people to handle during
installation. It is recommended to have three or more
people available to assist with lifting the unit into place.
Removal of the bottom hinge oven door during installation
(to provide the necessary handholds and to significantly
reduce the unit weight) can be cumbersome unless the
detailed door removal instructions are followed carefully.
Note: Do not attempt to remove the side hinge door (some
models).
Please take time to read and follow the instructions
provided for an improved installation experience.
Checklist
Use this checklist to verify that you have completed each
step of the installation process. This can help you avoid
common mistakes.
___ 1. Before installing the oven, be sure to verify the
cabinet dimensions are correct for your unit and
the required electrical connections are present.
___ 2. Refer to the installation manual for content
regarding Safety, Cabinet Dimensions, Removing
Packaging, Electrical Installation, Testing the
Installation and Customer Service.
___ 3. Remove the oven door(s) to reduce the unit weight
and to provide access to handholds for lifting.
___ 4. Move the oven unit into place in front of the cabinet
opening, leaving the bottom packaging on the unit
to avoid damaging flooring.
___ 5 Remove the T20 screws holding the unit to the
base of the carton (using Star-head screwdriver).
___ 6. If installing a combination unit (oven and
microwave or oven and steam oven) complete the
assembly before installing the unit.
___ 7. Team lift the unit directly into the cabinet cutout
taking care not to pinch fingers or scratch hands or
arms. Make sure the electrical conduit reaches to
the connection point properly.
___ 8. Slide the unit all the way into place, making sure to
route the electrical conduit correctly.
___ 8. Fasten the oven unit to the cabinetry opening with
the screws supplied (using Philips screwdriver).
___ 10. Reinstall the oven door(s) removed in step 2
above.
___ 11. Consult the complete installation instructions and
follow the remainder of the procedures listed,
including performing an operation test.
___ 12. All product literature and accessories (may be
wrapped or boxed) with the oven.
___ 13. INSTALLER - Leave the literature pack and the
accessories with the customer.