Electrolux EN2401AOX - Manual (Page 67)

67 ENGLISH 67 ENGLISH
8. INSTALLATION
WARNING!
Read the “Safety Information”
carefully for your safety and correct
operation of the appliance before
installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
8.2 Location
Important! There is a need of good
ventilation around the fridge for easy
dissipation of heat, high efficiency of
refrigeration and low power consumption.
For this purpose, sufficient clear space
should be available around the fridge. It is
advisable for there to be 75mm separating
the back of the fridge to the wall, at least
100mm of space at its two sides,height of
over 100mm from its top and a clear space
upfront to allow the doors to open 160°.
Climate
class
Ambient temperature
SN +10°Cto + 32°C
N +16°Cto + 32°C
ST +16°Cto + 38°C
T +16°Cto + 43°C
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible after
installation.
8.3 Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not
observed.
This appliance complies with the
E.E.C. Directives.