beautypg.com

Troubleshooting, 4 defrosting the freezer – Electrolux EN2401AOX User Manual

Page 64

background image

64 www.electrolux.com

6.4 Defrosting the freezer

Defrosting in freezer compartment

operated manually. Before defrosting,

take the food out.
Take the ice tray and drawers out or put

them into the fresh food compartment

temporarily.
Set the knob of the temperature

regulator to position “0” (where the

compressor will stop working) and leave

the door open until ice and frost dissolve

thoroughly and accumulation at the

bottom of the freezer compartment.

In the case of speeding up the process

of defrosting, you may put a bowl of warm

water (about 50°C) into the freezer com-

partment, and scrape away the ice and

frost with a defrosting spatula. After doing

so,be sure to set the knob of the tempera-

ture regulator to the original position.
It is not advisable to heat the freezer com-

partment directly with hot water or hair

dryer while defrosting to avoId deformation

of the inner case. It is also not advisable

to scrape off ice and frost or separate

food from the containers which have been

congealed together with the food with

sharp tools or wooden bars, so as not to

damage the inner casing or the surface of

the evaporator.

7. TROUBLESHOOTING

CAUtIoN!

Before troubleshooting, disconnect

the power supply. Only a qualified

electrician or competent person

must do the troubleshooting that

is not in this manual.

WARNING!

There are some sounds

during normal use (compressor,

refrigerant circulation).

problem

possible cause

Solution

The appliance is noisy.

The appliance is not

supported properly.

Check if the appliance

stands stable (all the four

feet should be on the floor).

The compressor

operates continually.

The Temperature regulator

may be set incorrectly.

Set a warmer temperature.

The door is not

closed correctly.

Refer to "Closing the door".

The door has been

opened too frequently.

Do not keep the door open

longer than necessary.

The product temperature

is too high.

Let the product

temperature decrease to

room temperature before

storage.

The room temperature

is too high.

Decrease the room

temperature.

Water flows on the rear

plate of the refrigerator.

During the automatic

defrosting process, frost

defrosts on the rear plate.

This is correct.

This manual is related to the following products: