Electrolux EN2401AOX - Manual (Page 65)

65 ENGLISH
problem possible cause Solution
Water flows into
the refrigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent
that water flows into
the water collector.
Make sure that products
do not touch the rear plate.
Water flows on
the ground.
The melting water
outlet does not flow
in the evaporative tray
above the compressor.
Attach the melting water
outlet to the evaporative
tray.
There is too much
frost and ice.
Products are not
wrapped properly.
Wrap the products better.
The door is not closed
correctly.
Refer to "Closing the door".
The Temperature regulator
may be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too low.
The Temperature regulator
may be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too high.
The Temperature regulator
may be set incorrectly.
Set a lower temperature.
The door is not
closed correctly.
Refer to "Closing the door".
The product temperature
is too high.
Let the product tem-
perature decrease to room
temperature before storage.
Many products are stored
at the same time.
Store less products
at the same time.
The temperature in the
refrigeration is too high.
There is no cold air circu-
lation in the appliance.
Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too high.
Products are too near to
each other.
Store products so that
there is cold air circulation.
The appliance does
not operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly.
Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no voltage
in the mains socket.
Connect a different
electrical appliance to
the mains socket. Contact
a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing
the lamp".
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.