Agilent Technologies 34970A - Manual (Page 10)

Mx+B Scaling Commands
(see page 244 in the User’s Guide)
CALCulate
:SCALe:GAIN <
gain >[,( @ < ch_list >)]
:SCALe:GAIN? [( @ < ch_list >)]
:SCALe:OFFSet < offset >[,( @ < ch_list >)]
:SCALe:OFFSet? [( @ < ch_list >)]
:SCALe:UNIT < quoted_string >[,( @ < ch_ list >)]
:SCALe:UNIT? [( @ < ch_list >)]
CALCulate:SCALe:OFFSet:NULL [( @ < ch_list >)]
CALCulate
:SCALe:STATe {OFF|ON}[,(
@ < ch_list >)]
:SCALe:STATe? [( @ < ch_list >)]
Alarm Limit Commands
(see page 247 in the User’s Guide)
OUTPut
:ALARm[
1 |2|3|4]:SOURce ( @ < ch_list >)
:ALARm[ 1 |2|3|4]:SOURce?
CALCulate
:LIMit:UPPer <
hi_limit >[,( @ < ch_ list >)]
:LIMit:UPPer? [( @ < ch_list >)]
:LIMit:UPPer:STATe {OFF|ON}[,( @ < ch_list >)]
:LIMit:UPPer:STATe? [( @ < ch_list >)]
CALCulate
:LIMit:LOWer <
lo_limit >[,( @ < ch_ list >)]
:LIMit:LOWer? [( @ < ch_list >)]
:LIMit:LOWer:STATe {OFF|ON}[,( @ < ch_list >)]
:LIMit:LOWer:STATe? [( @ < ch_list >)]
SYSTem:ALARm?
OUTPut
:ALARm:MODE {
LATCh |TRACk}
:ALARm:MODE?
:ALARm:SLOPe {
NEGative |POSitive}
:ALARm:SLOPe?
OUTPut
:ALARm{1|2|3|4}:CLEar
:ALARm:CLEar:ALL
STATus
:ALARm:CONDition?
:ALARm:ENABle <
enable_value >
:ALARm:ENABle?
:ALARm[:EVENt]?
Ch 01
DIO (LSB)
Ch 02
DIO (MSB)
Ch 03
Totalizer
Ch 04
DAC
Ch 05
DAC
CALCulate
:COMPare:TYPE {EQUal|
NEQual }[,( @ < ch_list >)]
:COMPare:TYPE? [( @ < ch_list >)]
:COMPare:DATA < data >[,( @ < ch_list >)]
:COMPare:DATA? [( @ < ch_list >)]
:COMPare:MASK < mask >[,( @ < ch_list >)]
:COMPare:MASK? [( @ < ch_list >)]
:COMPare:STATe {OFF|ON}[,( @ < ch_list >)]
:COMPare:STATe? [( @ < ch_list >)]
This command applies to all channels in the instrument (Global setting).
Default parameters are shown in bold.
10