Multi-tasker – Altinex MT104-100/103 User Manual
Page 22
MULTI-TASKER™
400-0082-005
21
21
Cause 2
The card and its serial device are
not communicating.
Solution 1: Turn the system OFF and then ON
again. If there is still an error, see
Solution 3.
Solution 2: Call ALTINEX at (714) 990-2300.
Cause 3:
RS485 communication error
Solution 1: Make sure that the card is pushed
all the way into the slot. If there is
still an error, see Solution 2.
Solution 2: Turn the system OFF and then ON
again. If there is still an error, see
Solution 3.
Solution 3: If there is still a problem, call
ALTINEX at (714) 990-2300.
8.3 NO DISPLAY
Cause 1:
The source has a problem.
Solution:
Check the source and make sure
that there is a signal present and all
source connections are correct. If
the source is working and there is
still no display, see Cause 2.
Cause 2
The card input is not selected.
Solution:
Select the card input. See RS-232
accessible commands in section 7.
If there is still no display present,
see Cause 3.
Cause 3
Cable connections are incorrect.
Solution:
Make sure that the cables are
connected properly. Also, make sure
that the continuity and wiring are
good. If there is still no display
present, see Cause 4.
Cause 4:
The display has a problem.
Solution:
Make sure that the display is
powered. If there is still no display,
call ALTINEX at (714) 990-2300.
ALTINEX POLICY
9
9.1 LIMITED WARRANTY/RETURN POLICY
Please see the Altinex website at
www.altinex.com
for details on warranty and
return policy.
9.2 CONTACT INFORMATION
ALTINEX, INC
592 Apollo street
Brea, CA 92821 USA
TEL: 714 990-2300
TOLL FREE: 1-800-ALTINEX
WEB:
www.altinex.com
E-MAIL: