Altinex MT104-100/103 - Manual (Page 12)

MULTI-TASKER™
400-0082-005 11
11
Example:
All of the inputs on the MT104-100/103 card are
OFF. The card is in slot #5 of Unit 3:
1) [ON1C5U3]: Turns ON only input 1 of the
MT104-100/103 card.
2) [ON3C5U3]: Turns ON only input 3 (input 1
is now OFF).
[ONmGkUi]: Group of Cards
This command enables input "m" for each card
in group "k" of unit "i".
m = Input Number (m = 1 to max inputs)
Gk = Group Number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
[ON1G1U1]: Turns ON input 1 for each card in
Group 1 of Unit 1.
PATH OPTION
[ON…..P]: Sets Path
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
preloaded.
Command Format: [ONmCnUiP]
m = Input (m = 1 to max inputs)
Cn = Card ID (n = slot # from 1 to max slots)
P = Path
Example:
There are two MT104-100/103 cards in slots 6
and 7. Use the following commands to enable
input 1 of card 6 and input 3 of card 7
simultaneously:
[ON1C6P]
[ON3C7P]
[SW]
FEEDBACK OPTION
If "F" is included, use the [ONmCnUiPF]
command or the [ONmCnUiFP] command.
[ON…..F]: Feedback
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
Example:
[ON1C2F]: if path is not set
[ON1C2PF]: if path is set
8. [OFF]
This command disables the output of a single
card or a group of cards.
[OFFmCnUi]: Single Card
m = Input Number that is ON (optional)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID number (i = 0 to 9)
Example:
Card 5 has Input 1 ON. The following
commands can be used to turn OFF the output.
1) [OFF1C5]: Turns OFF only input 1.
2) [OFFC5]: Turns OFF any input.
[OFFmGkUi]: Group of Cards
This command disables input "m" for each card
in group "k" of unit "i".
m = Input Number that is ON (optional)
Gk = group number (k = # from 1-8)
Ui = unit number (i = # from 0-9)
Example:
1) [OFF1G1]: Turns OFF input 1 for each card
in Group 1.
2) [OFFG1]: Turns OFF any input for each
card in Group 1.