Canon Wireless Transmitter WFT-E5A - Manual (Page 109)

109
Responding to Error Messages
This error occurs if, for some reason, the transmitter fails to receive confirmation
from the FTP server that image file transfer is complete.
X Restart the FTP server and camera and send the images again.
Is the Bluetooth unit too far from the GPS device?
X Bring the GPS device closer to the Bluetooth unit.
Are any obstacles blocking the line of sight between the Bluetooth unit and the
GPS device?
X Move the GPS device to a position visible from the point of view of the Bluetooth unit.
The Bluetooth unit and GPS device were disconnected, for some reason, and the
connection cannot be restored.
X The connection is more likely to be lost if there are nearby wireless LAN terminals,
cordless telephones, microphones, microwave ovens, or similar devices operating on the
same 2.4 GHz band used for Bluetooth communication. Also note that the connection is
more likely to be lost in poor weather or high humidity.
Is the GPS device on?
X Turn the GPS device on.
Is the GPS device ready for the Bluetooth connection?
X Turn the GPS device on and set it up for connection via Bluetooth.
Is the Bluetooth unit too far from the GPS device?
X Bring the GPS device closer to the Bluetooth unit.
Is the GPS device on?
X Turn the GPS device on.
Is the same password set on the Bluetooth unit and GPS device?
X The setting is case-sensitive, so check upper- and lower-case characters. Make sure the
correct password is entered on the GPS device and Bluetooth unit.
The GPS device does not support SPP (Serial Port Profile).
X Confirm that the GPS device supports SPP.
47: Image file transfer completion not confirmed by FTP server
51: Connection with Bluetooth unit lost
52: Bluetooth unit not found
53: Incorrect Bluetooth password
54: No Bluetooth service
COP
Y