Canon imagePROGRAF iPF8400 User Manual
Basic guide
Table of contents
Document Outline
- Cover
- Preface
- Handling Paper
- Consumables and Maintenance
- Printer Parts
- Printer Relocation
- Software Installation
- Adjustments for Better Print Quality
- Troubleshooting
- Problems Regarding Paper
- Clearing Jammed Roll Paper
- Clearing a Jammed Sheet
- Roll paper cannot be inserted into the paper feed slot
- Cannot load sheets
- Paper is not cut straight
- Paper is not cut
- The media take-up unit continues rotating
- The size of clear film cannot be detected
- Margins are wide
- When printing on thin roll paper, the printed surface becomes scratched
- Printing does not start
- The printer stops during a print job
- Problems with the printing quality
- Printing is faint
- Paper rubs against the printhead
- The edges of the paper are dirty
- The surface of the paper is dirty
- The back side of the paper is dirty
- Immediately after borderless printing, the trailing edge margin is soiled during regular printing
- Printed colors are inaccurate
- Banding in different colors occurs
- Colors in printed images are uneven
- Image edges are blurred or white banding occurs
- Setting the Blue Switch on the Platen
- The contrast becomes uneven during printing
- The length of printed images is inaccurate in the feeding direction
- Images are printed crooked
- Documents are printed in monochrome
- Line thickness is not uniform
- Lines or colors are misaligned
- Borders appear in borderless printing
- Cannot print over a network
- Installation problems
- Other problems
- Problems Regarding Paper
- Error Message
- Messages regarding paper
- Paper mismatch
- MediaType Mismatch
- The paper is too small.
- The paper is too small.
- PaprWidth Mismatch
- Paper size not detected.
- Insufficient paper for job
- This paper cannot be used as size is not supported.
- Roll printing is selected.
- Roll printing is selected, but sheets are loaded.
- The roll is empty.
- No sheets.
- Sheet printing is selected.
- Regular printing is selected, but a roll is loaded.
- Paper jam.
- Paper loaded askew.
- Cannot detect papr
- Cannot feed paper.
- Cannot cut this paper.
- End of paper feed.
- Rel lever is in wrong position.
- Rewinding error.
- Media take-up unit ready.
- Turn on the media take-up unit.
- Borderless printng not possible.
- Paper position not suitable for borderless printing.
- Messages regarding ink
- Messages regarding printing or adjustment
- Cannot execute this command. Use other paper.
- Cannot calibrate.
- Excessive temperature or humidity.
- Please execute common calibration.
- Please commn calibrt using above paper.
- Please calibrate using above paper.
- Borderless printng not possible. Paper stretched or shrank.
- Before borderless printing, move the blue platen switch.
- Blue platen switch is dirty.
- Move the blue platen switch No.xx to the right. (xx represents a number)
- Cannot adjust paper feed.
- Check printed document.
- Messages regarding printheads
- Messages regarding the maintenance cartridge
- Messages regarding the hard disk
- Other Messages
- GARO Wxxxx (x represents a number)
- ERROR Exxx-xxxx (x represents a letter or number)
- Hardware error. xxxxxxxx-xxxx (x represents a letter or number)
- Top cover is open.
- Prepare for parts replacement.
- Parts replacement time has passed.
- Unknown file.
- Calibration There is a problem with the multi-sensor.
- Multi-sensor error
- Error Messages
- Messages regarding paper
- Index