Access points in the list, Cop y – Canon PowerShot N User Manual
Page 96
96
1
2
3
4
5
6
8
9
10
Cover
Preliminary Notes and
Legal Information
Contents: Basic
Operations
Camera Basics
Creative Shot
Mode
Auto Mode/
Hybrid Auto Mode
Other Shooting
Modes
Playback Mode
Setting Menu
Accessories
Appendix
Index
Basic Guide
P Mode
7
Advanced Guide
Wi-Fi Functions
•
If you chose [PIN Method] in step 5, a PIN code will be displayed on the
screen. Be sure to set this code in the access point. Choose a device in the
[Select a Device] screen. For further details, refer to the user guide included
with your access point.
•
To add multiple computers, repeat the above procedures starting from step 1.
•
When finished adding computers, touch [
^] in the upper right of the image
transfer screen displayed after you connect to a computer in step 7. Touch
[OK] after the confirmation message.
•
To disconnect from the camera, turn off the camera.
•
When a connection destination is set using the Touch Actions setting
(
76), you can automatically access the function to connect to the last
connected destination from the next time by just dragging on the screen
without needing to perform the connection operation.
Connecting to Access Points in the List
1
View the listed access points.
z
z
View the listed access points as
described in steps 1 – 3 of “Adding a
Computer” (
2
Choose an access point.
z
z
Touch the network (access point) that you
want to connect to.
3
Enter the access point’s
encryption key.
z
z
Touch inside the frame shown at left to
access the keyboard, and then enter the
encryption key (
z
z
Touch [Next].
4
Choose [Auto].
z
z
Touch [Auto].
X
X
A list of other devices connected to the
access point will appear in the [Select a
Device] screen.
5
Choose a computer to connect
to.
z
z
Choose the computer to connect to,
following steps 7 – 8 in “Adding a
Computer” (
95). The computer is
now added to the list.
•
For information on the access point’s encryption key, refer to the body of the
access point or its user manual.
•
Up to 16 access points will be displayed. If no access points are detected,
choose [Manual Settings] in step 2 to manually set an access point. Follow
on-screen instructions and enter an SSID, security settings, and an encryption
key.
•
When you use an access point that you have already connected to for
connecting to another device, [*] is displayed for the encryption key in step 3.
To use the same encryption key, touch [Next].
•
To add multiple computers, repeat the above procedures starting from step 1.
COP
Y