beautypg.com

Safety and grounding – American Power Conversion AP7610 User Manual

Page 3

background image

Rack Power Distribution Unit — AP7610

3

Safety and Grounding

Read the following information before installing or operating your APC
AP7610 Rack PDU:

• The Rack PDU is intended only for use with four-wire grounded

connections on APC Uninterruptible Power Supplies (UPS). Do
not plug the Rack PDU into a wall outlet or other device.

• This Rack PDU is intended to be installed and operated only with

the provided mounting hardware.

• This Rack PDU is intended for indoor use only.

• Do not install this Rack PDU where excessive moisture or heat is

present.

• Do not use extension cords or adapters with this Rack PDU.

• Check that the power cord, plug, and socket are in good condition.

• Disconnect the Rack PDU from the power outlet before you install

or connect equipment to reduce the risk of electric shock when you
cannot verify grounding. Reconnect the Rack PDU to the power
outlet only after you make all connections.

• Install the Rack PDU so that the power plug may be disconnected

for service. The socket-outlet shall be installed near the equipment
and shall be readily accessible.

• Install the Rack PDU so that there is not an uneven mechanical

load.

• Follow the nameplate ratings when connecting equipment to the

supply circuit. Do not overload the circuits. An overload condition
could put your over-current protection at risk or cause problems
with your supply wiring.

• This Rack PDU contains a non-replaceable lithium coin cell

battery. Do not attempt to replace the battery.

Caution

Risk of electrical shock. Use only the supplied hardware to
attach the mounting brackets.