ACR Electronics Nauticast Y1-03-0203 User Manual

Page 56

User Manual

Y1-03-0203 Rev.L

Use this menu to set up the data speed 4800/9600/38400 baud.

NOTE: This Configuration should be done from advanced user like installation technicians only.
Therefore you will find more details in the installation manual.
During the configuration process, the NAUTICAST is not operational.

GPS Settings (Service Password protected)

GPS Module:
The screen provides means to switch the GPS Module between the

„<µBlox>‟ or „‟. You can

force the AIS to search again for the GPS Module installed. Selecting the wrong type of GPS module
may result in invalid position information and/or malfunction so that your AIS can not operate correct.
Select and with [Left] & [Right] arrows the option

to search which module is installed
Please mention the system will restart automatically when saving these setting later. .

Pos.Pinning:
The screen provides means to switch the position pinning function of the internal GPS receiver
and . For vessels operating with SOG < 0,3 knots it is recommended to switch position pinning
Off. Otherwise the internal GPS receiver may deliver wrong position information.
The data input field is fitted with the recommended default value (). The M6 button is used for
toggling between the two modes of position pinning; the M5 button is used for saving the settings.

NOTE: The system will be restarted after saving the settings.

Dynamic Keys: Sensor Settings

[M5] [Save]

Save Data Input [M8] [Back]

Return to Menu
Configuration

N48^12' E 16^26' |1> N/A|2> N/A|3>0.00nm
************* GPS Settings *************

GPS module :
Pos. Pinning: On

NOTE: The system will restart
when saving these settings.

----------------------------------------
| Save | | | Back