beautypg.com

AVerMedia Technologies AVERDIGI EB1304 User Manual

Page 24

background image

18

OSD MENU

Description

010 SEC
010 SEC
NOT INSTALLED
NOT INSTALLED
NOT INSTALLED
NOT INSTALLED

SENSOR SETUP
SENSOR REC TIME
ALARM OUT TIME
CHANNEL - 1
CHANNEL - 2
CHANNEL - 3
CHANNEL - 4

SENSOR REC TIME :

Set the amount of time (in second) to start record when
the sensor has triggered

ALARM OUT TIME :

Set the amount of time (in second) to continue sending
the alarm once triggered

CHANNEL 1~4 :
Customize the initial state of the attached sensor. Refer
to the table below to customize the sensor state

Condition

Description

NOT INSTALLED

Indicates that there is no sensor connected

NORMAL OPEN

Indicates that the initial state of the sensor is
normal open. Video recording initiates when
there is a changes in the sensor state

NORMAL CLOSE Indicates that the initial state of the sensor is

normal close. Video recording initiates when
there is a changes in the sensor state

1

2

3

4

L
010 SEC

MOTION SETUP
MOTION CAMERA
SENSITIVITIY
MOTION RECORD TIME

MOTION CAMERA :
Enable/disable the channel number to detect motion.
SENSITIVITY :
Set the sensitivity level. The sensitivity is from H (High),
9~ 2 and L (Low).
MOTION RECORD TIME :
Set the amount of time (in second) to record when
motion is detected.

1

2

3

4

5001
5005

NETWORK SETUP
IP MODE
NW ENABLE
VIDEO PORT
UPGARDE PORT

STATIC

NETWORK SETUP:
Setup the network parameters for the internet or
intranet remote monitor or playback.

IP MODE:
The system provides 3 types of IP setup mode – Static,
DHCP, and PPPOE.

Use

and

buttons to go up and down and

select IP MODE, and then press

. Use

and

buttons to change the selections and press

or

to make a selection.

„

STATIC: Assigns a constant IP address for the

DVR system. Use

and

buttons to go

up and down and select items, and then press

or

to make selection. Use

and

to move left and right to select or enter the
configuration value.
-

IP ADDRESS: Assign a constant IP address

which a real IP addresses give from ISP to DVR
system.

-

SUBNET: It is a bitmask used to identify the sub
network and how many bits provide room for