Brother HL-S7000DN - Manual (Page 91)

General Information
85
3
WLAN TCP/IP Boot Method Auto* / Static / RARP /
BOOTP / DHCP Chooses the IP method that
best suits your needs.
IP Address ###.###.###.###
(000.000.000.000)*
1
Enter the IP address.
Subnet Mask ###.###.###.###
(000.000.000.000)*
1
Enter the Subnet mask.
Gateway ###.###.###.###
(000.000.000.000)*
1
Enter the Gateway address.
Node Name BRWXXXXXXXXXXXX Enter the Node name.
WINS Config Auto* / Static Chooses the WINS
configuration mode.
WINS Server (Primary)
000.000.000.000
(Secondary)
000.000.000.000 Specifies the IP address of the
primary or secondary WINS
server.
DNS Server (Primary)
000.000.000.000
(Secondary)
000.000.000.000 Specifies the IP address of the
primary or secondary DNS
server.
IP Boot Tries 0 / 1 / 2 / 3* / ... / 32767 Specifies the number of
attempts the machine will try to
obtain an IP address when the
Boot Method is set to any
setting except Static.
APIPA On* / Off Automatically allocates the IP
address from the link-local
address range.
1
IPv6 On / Off* Enables or Disables the IPv6
protocol.
Setup Wizard - - Configures the wireless
network settings using the
setup wizard.
WPS/AOSS - - Configures the wireless
network settings using WPS or
AOSS™ method.
WPS w/PIN
Code - - Configures the wireless
network settings using WPS
with a PIN code.
Network Menu (continued)
Submenu 1 Submenu 2 Menu Selections Options Descriptions
The factory settings are shown in Bold with an asterisk.