Brother HL-3075CW - Manual (Page 94)

Control Panel
89
3
1 On connection to the network, if the machine's 'IP METHOD' is 'AUTO' the machine will attempt to automatically set the IP address and Subnet
Mask from a boot server such as DHCP or BOOTP. If a boot server cannot be found an APIPA IP address will be allocated, such as
169.254.[001-254].[000-255]. If the 'IP METHOD' of the machine is set to 'STATIC' you will need to manually enter an IP address from the
machine's control panel.
WLAN
Status
(Appears only
when WLAN
Enable is
On.) Status
Signal
Channel
Speed
SSID
Shows SSID [uses a maximum
of 32 digits and characters 0-9,
a-z and A-Z in ASCII values]
Comm. Mode Ad-hoc*/Infrastructure Shows the current
Communication Mode.
Set to
Default Restores wired network settings
of the internal print server to the
factory default.
WLAN
Enable Off*/On Chooses Ethernet link mode.
Factory
Reset Restores all network settings of the internal print server to the factory default.
Reset Menu
Display Shows Description
Reset Printer Resets the printer and restores all printer settings (including command settings) to settings
you have previously made with the control panel buttons.
Factory Reset Resets the printer and restores the printer settings (including command settings) to the
factory default settings.
The factory settings are shown in Bold with an asterisk.
Color Correction
Submenu Menu Selections Options Descriptions
Frequency Normal*/Low/Off Sets the interval time you want to
carry out the auto color correction
Color Calibration Calibrate Carry out calibration to revise the
colors. (See Calibration on page 95.)
Reset Set the calibration parameters back
to the default settings. (See
Calibration on page 95.)
The factory settings are shown in Bold with an asterisk.
Network for HL-3075CW users (continued)
Submenu 1 Submenu 2 Menu Selections Options Descriptions
The factory settings are shown in Bold with an asterisk.