4 jmicron® raid configuration, Jmicron, Raid configuration -33 – Asus Z7S WS User Manual
Page 143: 4 jmicron, Raid configuration, Before creating a raid set, The jmicron, Windows, Os had been installed
ASUS Z7S WS
5-33
5.4.4
JMicron
®
RAID Configuration
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows Vista)
3. Microsoft
®
Windows
®
OS installation disk (Windows XP)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the two external Serial ATA hard disk drives on your system.
2. Set the
Controller Mode item in the BIOS to [RAID]. See section 4.4.4
Onboard Device Configuration for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
®
OS installation. See section
5.5 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows
®
OS had been installed.
Always install the JMB363 driver before creating RAID sets.
Onboard Devices Configuration
Serial Port1 Address
[3F8/IRQ4]
J-Micron eSATA/PATA Controller [Enabled]
Controller Mode
[IDE]
Front Panel Support Type
[AC97]
Onboard 1394
[Enabled]
Onboard LAN
[Enabled]
Onboard LAN Boot ROM
[Disabled]
PCI Express x1
[Auto]
Primary Display Adapter
[PCI-E]
Allows BIOS to Select
S e r i a l P o r t 1 B a s e
Addresses.
BIOS SETUP UTILITY
Advanced
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit