Button sewing – Brother XL-5130 5232 5340 User Manual

Page 57

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

Button Sewing

Pattern

Stitch Length

Stitch Width

Foot

(Zigzag Stitch)

Any

Button

Sewing Foot

1. Measure the distance between the holes and set the appropriate

stitch width with the stitch width dial. For example, if the distance
between the holes is 1.5 mm (1/16"), set the stitch width to “1.5”.

2. Attach the button sewing foot.
3. Place the darning plate on the needle plate.

(When the machine is equipped with a drop feed lever, lower the
feed dogs by setting the drop feed lever to the up position.)

4. Place a button between the foot and the fabric and make sure that

the needle enters the holes without hitting the button. If it hits, see
step 1.

5. At a slow speed, sew approximately 10 stitches.
6. Remove the material from the machine. Cut the upper and lower

threads and tie the two threads at the back of the fabric.