Brother MFC-3820CN - Manual (Page 168)

TROUBLESHOOTING AND ROUTINE MAINTENANCE 13 - 21
6
Hold the new ink cartridge as shown in the illustration, and then
peel the sealing tape from the side of the ink cartridge.
Carefully peel the tape in the direction away from you.
7
Each color has its own correct position. Insert each new ink
cartridge into the carriage.
8
After installing the ink cartridge, close the scanner cover.
Your MFC prepares for a “head cleaning” and goes online.
The LCD prompts you to verify that you removed the ink
cartridge for each color. Example:
Have you removed Blck?
1.Yes 2.No.
9
If you removed the ink cartridge, press 1
—OR—
If you did not remove the ink cartridge, press
2 .
The LCD prompts you to verify that the ink cartridge was a new
one. Example:
Changed to new Blck? 1.Yes 2.No.
10
If the ink cartridge you installed is not a brand new one, please
be sure to press
2 .
—OR—
For each new cartridge, press 1 on the dial pad to automatically
reset the ink dot counter for that color. (The ink dot counter
enables the MFC to notify you when a color is running low.)
The MFC will enter a cleaning cycle for approximately 3 minutes
for each replaced cartridge. The LCD alternately shows
Cleaning and Please Wait .
When the MFC completes the cleaning cycle, the LCD returns
to Standby mode condition.
To prevent spilling ink and staining your hands and clothing,
remove the sealing tape gently.
Peel in the direction
away from you!
Opening