Brother MFC-7440N - Manual (Page 29)

Control panel setup
21
3
Gateway
3
This field displays the current gateway or router address used by the machine. If you are not using DHCP or
BOOTP to obtain the gateway or router address, enter the address you wish to assign. If you do not have a
gateway or router, leave this field blank. Check with your network administrator if you are unsure.
a Press Menu.
b Press a or b to choose LAN.
Press OK.
c
Press a or b to choose TCP/IP.
Press OK.
d
Press a or b to choose Gateway.
Press OK.
e (For MFC-7440N)
Press 1 to choose Change.
(For DCP-7045N)
Press a to choose Change.
f
Enter the Gateway address.
Press OK.
Note
For DCP-7045N, press a or b repeatedly to enter the first three-digit number for the Gateway address.
Press OK to enter the second three-digit number. Repeat this step until you have entered the fourth
three-digit number to complete the Gateway address. Press OK.
g
Press Stop/Exit.
Node Name
3
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
“BRNxxxxxxxxxxxx”.
a
Press Menu.
b
Press a or b to choose LAN.
Press OK.
c Press a or b to choose TCP/IP.
Press OK.
d Press a or b to choose Node Name.
Press OK.
(For MFC-7440N) Go to e.
(For DCP-7045N) Go to f.