Brother MFC-440CN - Manual (Page 12)

Installing the Driver & Software
10
STEP 2
Windows
®
W
ind
ow
s
®
Netw
o
rk
2
For Network Interface Users
The installation steps for the MFL-Pro Software Suite and drivers will depend on your model number.
Please check the table below for the correct installation method for your model.
For MFC-440CN, MFC-5460CN and MFC-5860CN
users
Important
Make sure that you have finished the
instructions from STEP 1 Setting Up the
Machine in the Quick Setup Guide.
Note
• Please close any applications running before
installing MFL-Pro Suite.
• If your machine has media drives (slots), make
sure there are no memory cards in the media drive
of the machine.
(The illustrations are based on MFC-5460CN.)
1
Turn off and unplug the machine from the AC
outlet and from your network, if you already
connected an interface cable.
2
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
3
Insert the network cable into the LAN socket
marked with a
symbol. You will find the
LAN socket inside the machine on the left as
shown below.
4
Carefully route the network cable through the
trench and out the back of the machine.Then,
connect the cable to your network.
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used, guide
both cables through the trench with one on top of
the other.
Model Number Page Number
MFC-440CN, MFC-5460CN, MFC-5860CN page 10
DCP-8065DN, MFC-7225N, MFC-7820N, MFC-8460N, MFC-8860DN page 14