Brother TD-2020 - Manual (Page 9)

7
EN
Regulation
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Federal Communications Commission (FCC) Declaration of Conformity (For USA Only)
Responsible Party:
Brother Mobile Solutions, Inc.
100 Technology Drive Suite 250A
Broomfield, CO 80021 U.S.A.
Tel: (303) 460-1600
Product Name: Thermal Printer
Model Number: TD-2020/2120N/2130N
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
Important
•
The enclosed interface cable should be used in order to ensure compliance with the limits for a
Class B digital device.
•
A shielded interface cable should be used in order to ensure compliance with the limits for a Class
B digital device.
•
Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user's
authority to operate the equipment.
*
In case either WLAN Interface(optional) or Bluetooth Interface(optional) is in use.
CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only the supplied
antenna. Unauthorize antenna, modification, or attachments could damage the transmitter and
may violate FCC regulations.