Power supply, Battery – Brother PT-H500 User Manual
Page 25
25
G
E
TTI
N
G
STA
R
TED
Power Supply
Battery
After making sure that the power is off, remove the
rear cover on the back of the P-touch labeler. If the
batteries are already in the P-touch labeler, remove
them.
Insert six new AA-size alkaline batteries (LR6), or fully
charged Ni-MH rechargeable batteries (HR6), making
sure that the positive (+) and negative (-) ends of the
batteries match the positive (+) and negative (-) marks
inside the battery compartment.
Users of alkaline batteries
23
Users of Ni-MH rechargeable batteries
Attach the rear cover by inserting the three hooks at
the bottom into the slots on the P-touch labeler, then
pushing down firmly until it snaps into place.
Power Supply
Make sure that the power is turned off
when replacing batteries.
1
Always replace all six batteries at the
same time using brand new ones.
Always replace all six batteries at the
same time with fully charged ones.
Visit us at
for the latest information about the
recommended batteries.
If you cannot attach the rear cover, check
to ensure the white lever is in the up
position. If not, lift the lever, and then
attach the cover.
2
3
Remove the batteries if you do not intend to use the P-touch labeler for an extended
period of time.