Brother MFC-J435W - Manual (Page 5)

1
1
1
IMPORTANT NOTE
1
 In this manual, the LCD messages of the MFC-J430W are used unless specified.
 Most of the illustrations in this User’s Guide show the MFC-J430W.
Memory storage
1
Even if there is a power failure, you will not
lose the settings you have chosen using the
Menu key because they are stored
permanently. Also, you will not lose your
settings in the FAX and COPY mode key
menus if you have chosen
Set New Default. You may have to reset
the date and time.
Volume Settings
1
Ring Volume
1
You can choose a range of ring volume
levels, from High to Off.
While the machine is idle, press
d
or c
to adjust the volume level. The LCD shows
the current setting, and each key press will
change the volume to the next level. The
machine will keep the new setting until you
change it.
You can also change the volume through the
menu, by following the instructions below:
Setting the Ring Volume from the
menu
1
a
Press Menu.
b
Press a or b to choose
General Setup.
Press OK.
c
Press a or b to choose Volume.
Press OK.
d
Press a or b to choose Ring.
Press OK.
e
Press a or b to choose Low, Med, High
or Off.
Press OK.
f
Press Stop/Exit.
General setup
1