TOHO ELECTRONICS TRM-006A - Manual (Page 18)

18
5.2 Setting a data length
5.3 Setting a stop bit length
5.4 Setting a parity
5.5 Setting a BCC check
The BCC check is disabled.
Initial value of MODBUS (RTU):
E c IInitial value of MODBUS (ASCII): E c I
^ g f o
＊＊＊
F Stop bit 1
I
Stop bit 2
c No parity
f Odd parity
D Even parity
N Data length, 7 bits
E Data length, 8 bits
* The RTU mode settings come only in three types: H H .
The ASCII mode settings come only in three types: H H .
5.6 Setting a communications speed
While in the "Set a communications speed" screen on the preceding page, operate the ▲ and ▼
keys to make the settings. The initial value is
H H .
^ j T L
＊＊＊＊
I 1200 BPS
K 2400 BPS
E 4800 BPS
M 9600 BPS
F I
19200 BPS
5.7 Setting an address
While in the "Set a communications address" screen on the preceding page, operate the ▲ and ▼
keys to make the settings. The initial value is
H .
^ i d h
F Setting range: 1 to 247 stations (It cannot be set to a 0.)