PATLITE BSV - Manual (Page 9)

- 9 -
5-2. Panel Mounting
(1) Please mount on a flat surface with a panel thickness of 1 mm to 3.5 mm for proper clamping (Refer to Installation
dimensional drawing�.
(2� Rotate the front cover counter-clockwise 45 degrees, and loosen the mounting screws.
(3) Referring to the "Section C Rear View" drawing, check that the mounting bracket is in position (A) before inserting
the product through the front of the panel. Place the mounting brackets as indicated in position (B� and secure it
with the mounting screws, clamping the mounting nut to the rear of the mounting surface. (Recommended torque: 0.3
N-m�
(4) Check that the product is securely mounted before placing the front cover back on.
Panel Mounting Dimension Diagram
※ Conforms to IEC-61554 (DIN-43700)
□68 mm
+0.7
-0
Installation Surface
Tighten
Loosen
Section
C
Position (A)
Position (B)
Section C Rear View
• Be sure the power is disconnected before wiring or installing this product. Possibility of electric shock,
short-circuiting or product failure may occur.
• Ensure the installation surface is sufficient enough to handle the weight of the product, and where there
is less vibration. Also, do not install in places which exceeds the specifications, such as a vehicle, etc.
Failure to comply may result in the prevention of the product detaching and falling, causing injury to a
passer-by, etc.
• Always use both mounting screws and tighten with the recommended torque. Failure to comply may result
in the prevention of the product detaching and falling, causing injury to a passer-by, etc.
• Do not apply a heavy load to the lead wires. Possibility of electric shock, short-circuiting or product failure
may occur.
• Do not turn the front cover more than 45 degrees. Failure to comply may result in product damage.
CAUTION