PATLITE BSV - Manual (Page 10)

- 10 -
Note
5-3. Wall Mounting
(1� Mount on a flat surface with a panel thickness of 1 mm to 3.5 mm for proper clamping.
(Refer to the “Panel-mount Dimension drawing”)
(2� Rotate the front cover counter-clockwise 45 degrees, and pull straight out to remove, then loosen and remove
the mounting screws and O-ring.
(3� Place the front cover in the same position as when removing it, insert the product onto the mounting surface from
the front, then install the mounting screws from the rear of the mounting surface.
(Recommended torque: 0.3 N-m�
(4) Check that the product has been properly clamped before placing the front cover back on.
Wall Mounting Dimension Diagram
(Product Front View)
□57.5
±0.2
2-φ3.5
[mm]
* For proper mounting, the length of the mounting screw can be changed to match the thickness of the panel.
• Install the product on a flat surface with no uneven surfaces. Failure to comply will weaken its
resistance to water and dust.
• If installing the product where vibrations exist, it is recommended to make periodic inspections to
ensure the mounting screws are properly tightened.
• If installing the product where vibrations exist, it is recommended to make periodic inspections to
ensure the mounting screws are properly tightened.
• When operating the product by controlling the power ON/OFF, be sure to include a switch by which the
power supply can be easily cut near the main power for safety.
• Do not block the air vents when installing.
• Do not apply thread locking adhesive to the cover locking screw, it may result in damage to the product.
• Depending on the mounting surface material, thickness and the volume of the product, a vibration
sound may be generated from the mounting screws. Take countermeasure steps by reinforcing the
mounting screws to reduce vibration.
Please