PATLITE BSV - Manual (Page 13)

- 13 -
7. Controlling The Volume
7-1. Volume Adjustment
The volume is adjustable from the minimum to maximum sound level.
The volume is to be used as the adjustment of the volume and not be used for muting.
- Volume adjustment should be done with a small Phillips screwdriver of about 0.5mm in width.
- The volume position is in reference to the increasing size of the “o” marking in conjunction with the po-
sition of the arrow.
* At the time of factory shipment, the volume is set at the mid-center position (indicated as “A”) as
depicted in the figure.
A
CAUTION
Note
• Turn the volume lightly when adjusting.
• If a torque more than 0.05 N-m is applied, there is a possibility of damaging the volume control.
• As the sound increases, the possibility of distortion may also occur.
• Due to the surrounding environment and electrical tolerances, Even with the volume adjusted to
minimum, the sound level may not be zero.