Ouellet OTR User Manual
Page 16
16
buffer zone to spend the remaining cable. Never shorten the heating cable.
The heating cable must not be shortened, neither cut.
– Avoid walking on the Therma Cable system. If you must, wear soft rubber soled
shoes;
– Always start the Therma Cable from at least 50 mm (2’’) to 76 mm (3’’)
from the walls;
– It is important not to subject the heating cable to any mechanical strain
(stretching, bending radius under 20 mm [¾”], scoring).
Fig. 4.4 c
IMPORTANT!
Never cut or score the heating cable.
Measure the cable’s electrical and insulation resistance and record
the readings on line 2) After installing the heating cable of the
measures’ table.
See also other documents in the category Ouellet Water boiler:
- OAC (1 page)
- OACP (1 page)
- OAE (1 page)
- OCH (1 page)
- OCH-RF (1 page)
- OCH-WB (1 page)
- OCP (1 page)
- ODL (1 page)
- ODS (3 pages)
- OFH (1 page)
- OFM (1 page)
- OHY (4 pages)
- ORC (2 pages)
- OTM (26 pages)
- OVB-HL (16 pages)
- OVB-QS (22 pages)
- OVE (2 pages)
- OVN (4 pages)
- OVR (1 page)
- OVS (1 page)
- OWC-M (26 pages)
- OWC-R (24 pages)
- OWS (26 pages)
- UFO-R (24 pages)
- WHFC (2 pages)
- RBH (2 pages)
- OAWH (1 page)
- OCA (1 page)
- OCB (1 page)
- ODIA (1 page)
- OEC (1 page)
- OHB (1 page)
- OLA (1 page)
- OLI (1 page)
- OMB (1 page)
- OPA (1 page)
- OPI (1 page)
- OPR (1 page)
- OAF (5 pages)
- OAM (4 pages)
- OAS-MD (1 page)
- OAV (1 page)
- OCC (1 page)
- OHV (4 pages)