4 installing the therma cable floor heating system – Ouellet OTR User Manual
Page 14
14
while the other will remain available as a replacement if the first one present
a malfunction. Each floor temperature sensors must be centered between two
parallel heating cables under the Therma Cable (Fig.4.3b). The ideal location
is one where it is likely to be away from stationary objects and sheltered from
outside influences (sunlight) that could skew floor temperature readings. For
maximum comfort, the area above the sensor must be free of obstruction;
– In a bathroom, when installing the Therma Cable, always allow a clearance
of at least 102 mm (4’’) on both sides of the toilet drain, this for avoiding the
melting of the toilet wax ring.
Fig. 4.3 b
4.4 Installing the Therma Cable Floor Heating System
heating cable
junction
channel
cold lead
Fig. 4.4 a
- OAC (1 page)
- OACP (1 page)
- OAE (1 page)
- OCH (1 page)
- OCH-RF (1 page)
- OCH-WB (1 page)
- OCP (1 page)
- ODL (1 page)
- ODS (3 pages)
- OFH (1 page)
- OFM (1 page)
- OHY (4 pages)
- ORC (2 pages)
- OTM (26 pages)
- OVB-HL (16 pages)
- OVB-QS (22 pages)
- OVE (2 pages)
- OVN (4 pages)
- OVR (1 page)
- OVS (1 page)
- OWC-M (26 pages)
- OWC-R (24 pages)
- OWS (26 pages)
- UFO-R (24 pages)
- WHFC (2 pages)
- RBH (2 pages)
- OAWH (1 page)
- OCA (1 page)
- OCB (1 page)
- ODIA (1 page)
- OEC (1 page)
- OHB (1 page)
- OLA (1 page)
- OLI (1 page)
- OMB (1 page)
- OPA (1 page)
- OPI (1 page)
- OPR (1 page)
- OAF (5 pages)
- OAM (4 pages)
- OAS-MD (1 page)
- OAV (1 page)
- OCC (1 page)
- OHV (4 pages)