AT&T E5913B - Manual (Page 10)

7
Getting started
LOW BATTERY
Battery installation & charging
After battery installation, the battery may have enough charge to allow for some
calls. For best performance, place the handset(s) in the telephone base or charger(s)
and allow to charge for 16 hours before use.
You can keep the battery charged by returning the handsets to the telephone base
or chargers after each use. When the battery is fully depleted, a recharge takes
about 12 hours. The average talk time on a fully charged battery is about eight hours
depending on environmental conditions, and the standby time is approximately five
days. Actual battery life will depend on usage conditions and age of battery.
3. Plug the battery
securely into the
plug inside the hand-
set battery compart-
ment, matching the
color-coded label.
Caution: Use only the supplied rechargeable battery or replacement battery (model 27910, part
number 89-0099-00-00). To order, visit our website at www.telephones.att.com or call 1 (800) 222-
3111. In Canada dial 1 (866) 288-4268.
To replace the battery, press in and
downward on the tab to open the
battery compartment cover. Then lift
out the old battery and disconnect.
Follow the instructions on this page
to install and charge the new battery.
5. Slide battery
c o m p a r t m e n t
cover towards
the center until it
clicks closed.
Low battery indicator
Return handset to the telephone base
or charger to recharge when this
symbol flashes, the handset screen is
dim or completely clear. (Handset will
beep when battery is low.)
4. Place the
battery pack
and wires
inside the
compartment.
1. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
2. Plug the
large end of the
smaller power
adapter into an
electrical outlet.