Dwyer EDA User Manual
Page 16
14
OUt Output Menu
CtrL
Control Mode
1SP
Single set point.
2SP
Two fully independent set points.
SPAL
Single set point and alarm.
1SP
SP1, Set Point 1, Reverse or Direct Acting
DIR
Direct. Relay turns on with increasing pressure.
REV
Reverse. Relay turns on with decreasing pressure.
DEL1
SP1, Set Point 1, Time Delay
Sets the amount of time a set point condition must be continuously met before the set point condition
is recognized. The DEL1 delay is adjustable from 0-60 seconds.
LEd1
SP1, Set Point 1, Lamp
OFF
The SP1 LED on the front panel turns OFF when the SP1 relay turns OFF.
The SP1 LED on the front panel turns ON when the SP1 relay turns ON.
ON
The SP1 LED on the front panel turns ON when the SP1 relay turns OFF.
The SP1 LED on the front panel turns OFF when the SP1 relay turns ON.
The following SP2 function values are only activated when CtrL is set to 2SP:
2SP
SP2, Set Point 2, Reverse or Direct Acting
DIR
Direct. Relay turns on with increasing pressure.
REV
Reverse. Relay turns on with decreasing pressure.
DEL2
SP2, Set Point 2, time delay
Sets the amount of time a set point condition must be continuously met before the set point
condition is recognized. The DEL2 delay is adjustable from 0-60 seconds.
LEd2
SP2, Set Point 2, Lamp
OFF
The SP2 LED on the front panel turns OFF when the SP2 relay turns OFF.
The SP2 LED on the front panel turns ON when the SP2 relay turns ON.
ON
The SP2 LED on the front panel turns ON when the SP2 relay turns OFF.
The SP2 LED on the front panel turns OFF when the SP2 relay turns ON.
LdL9
Relay Alternation (See page 8)
OFF
There is no alternating function.
ON
Relays will alternate with set points SP1H/L and SP2H/L with every cycle of set
points. 2SP control mode only.