Dwyer 3100MP - Manual (Page 2)

Table of Contents
Chapter 1. Introduction
1.1 Using This Manual
1.2 Overview of Transmitter
1.3 Software Compatibility
Chapter 2. Handling Cautions
2.1 Unpacking Transmitters and Specifications Check
2.2 Models and Specifications Check
2.3 Storage
2.4 Selecting Installation Locations
2.5 Calibration after Installation
2.6 Pressure Connections
2.7 Waterproofing Cable Conduit Connections
2.8 Restrictions on Use of Radio Transceiver
2.9 Installation Resistance Test and Dielectric Strength Test
2.10 Explosion-Proof Transmitters
2.11 EMC Conformity Standards
Chapter 3. Transmitter Functions
3.1 Overview
3.2 Safety Messages
3.3 Warning
3.4 Fail Mode Alarm
3.5 EEProm-Write Enable/Disable Mode Jumper
3.6 Configuration of Alarm and Security Jumper Procedures
3.7 Configuration of Zero and Span Procedures
3.8 Commissioning on the Bench with HHT
Chapter 4. Installation
4.1 Overview
4.2 Safety Messages
4.3 Warning
4.4 Commissioning on the Bench with Hand-Held Terminal
4.5 General Considerations
4.6 Electrical Considerations (Power Supply)
4.7 Wiring
4.8 Mechanical Considerations
4.9 Environmental Considerations
Chapter 5. On-line Operation
5.1 Overview
5.2 Safety Messages
5.3 Configuration Data Review
5.4 Configuration Verification
5.5 Basic Setup
5.6 Detailed Setup
5.7 Configuration Variables Setup
5.8 Diagnostics and Services
5.9 Calibration
Chapter 6. Maintenance
6.1 Overview
6.2 Safety Messages
6.3 Hardware Diagnostics
6.4 Hardware Maintenance
Appendix I
3100 Smart Pressure Transmitter LCD Display Code
HART ® is a registered Trademark of Hart Communication Foundation
Page 1