Crystal XP2i 2nd Generation - Manual (Page 28)

Support  26
XP2i Operation Manual
„ „
soFtWare
LabVIeW™ drivers and Programming Instructions
Control and communicate with XP2is using National Instrument’s LabVIeW , or our Programming Instructions. Integrate XP2is into your test environment!
configXP configuration software
Use configXP to disable unwanted pressure units, set default pressure units, change water density, adjust calibration, and more via the RS-232 interface.
„ „
rePLaceMent Parts
The only user-replaceable parts are the batteries.
„ „
accessorIes
P/n 2984 . . . ac adapter kit
Permits operation of an XP2i from an AC supply of 90 - 264 VAC and 47 - 63 Hz . Includes interchangeable international plugs (for USA, Europe, U .K ., and Australia) .
Adapter will not charge batteries, but in the event of AC power loss, XP2is will automatically revert to battery operation .
!
WARNING: do not use the ac adapter kit in hazardous locations.
P/n 3009 . . . Plastic carrying case
35 .6 cm (14”)L x 27 .9 cm (11”)W x 8 .3 cm (3¼”)H with egg-shell foam interior .
P/n 3696 . . . Protective Boot
Skydrol™ resistant protective boot .
!
WARNING: not assessed for use in hazardous locations.
P/n 2955 . . . 6” gauge adapter Kit
Adapts the 4½” Panel Mount (F4 option) to fit into a 6” gauge cutout .
P/n 2956 . . . 8½”gauge adapter Kit
Adapts the 4½” Panel Mount (F4 option) to fit into an 8½” gauge cutout .
P/n 3313 . . . usB-rs232 adapter
USB B receptacle to RS232 DB9M .
!
WARNING: do not use the usB adapter in hazardous locations.
P/n 2400 . . . rs232 cable
DB-9 male to DB-9 female straight pass-through cable .
!
WARNING: do not use rs232 cable in hazardous locations.